|
A tailings dam is typically an earth-fill embankment dam used to store byproducts of mining operations after separating the valuable fraction from the uneconomic fraction of an ore. Conventional water retention dams can serve this purpose, but due to cost, a tailings dam is more viable. Tailings can be liquid, solid, or a slurry of fine particles. Solid tailings are often used as part of the structure itself. Tailings dams rank among the largest engineered structures on earth. The Syncrude Mildred Lake Tailings Dyke in Alberta, Canada, is an embankment dam about long and from high. It is the largest dam structure on earth by volume, and as of 2001 it was believed to be the largest earth structure in the world by volume of fill. There are key differences between tailings dams and the more familiar hydro dams. Tailings dams are designed for permanent containment, meant to "remain there forever".〔http://www.pbs.org/wgbh/frontline/article/tailings-dams-where-mining-waste-is-stored-forever/〕 Copper, gold, uranium and other mining operations produce varied kinds of waste, much of it toxic, which pose varied challenges for long-term containment.〔http://www.vancouversun.com/technology/tailings+dams+work/10102756/story.html?__lsa=60ea-4ffb〕 An estimated 3,500 active tailings impoundments stand around the world. These structures experience "major" failures of about 2 to 5 annually, along with 35 "minor" failures.〔http://www.infomine.com/publications/docs/Martin2000.pdf〕 This failure rate is "more than two orders of magnitude higher than the failure rate of conventional water retention dams".〔http://www.infomine.com/library/publications/docs/Azam2010.pdf〕 == Structure == Unlike water retention dams, a tailings dam is raised in succession throughout the life of the particular mine. Typically, a base or starter dam is constructed, and as it fills with a mixture of tailings and water, it is raised. Material used to raise the dam can include the tailings (depending on their size) along with dirt. There are three raised tailings dam designs, the ''upstream'', ''downstream'' and ''centerline'', named according to the movement of the crest during raising. The specific design used is dependent upon topography, geology, climate, the type of tailings, and cost. An upstream tailings dam consists of trapezoidal embankments being constructed on top but toe to crest of another, moving the crest further upstream. This creates a relatively flat downstream side and a jagged upstream side which is supported by tailings slurry in the impoundment. The downstream design refers to the successive raising of the embankment that positions the fill and crest further downstream. A centerlined dam has sequential embankment dams constructed directly on top of another while fill is placed on the downstream side for support and slurry supports the upstream side.〔(【引用サイトリンク】 url=http://www.mining.ubc.ca/faculty/meech/MINE290/Tailings%20Dam%20Construction%20Methods.pdf )http://mining.ubc.ca/files/2013/03/Dirk-van-Zyl.pdf〕 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Tailings dam」の詳細全文を読む スポンサード リンク
|